SANITEC IC60 is a range of resin baseboards created for hygienic connections between floor and wall covering or between two walls, particularly in the healthcare, chemical and food fields. Designed for application on existing surfaces, they can be used for renovations and retrofitting of previously built public buildings, because they meet current regulations. Shaped outer edges ensure perfect adhesion of the profile to the substrate.

 

 

 

 

Hygienic cove shaped profiles between wall and wall and between wall and floor. Connections between the wall and the bathtub, the shower tray or the kitchen surface. The silicones that are normally used lose their anti-mold properties after a few months producing unsightly halos or stains. SB30 is a plastic profile with a rear support to facilitate the application and grip of the silicone with which it is installed on the walls. Improve or restore the appearance of the corners, making them more hygienic.

 DATASHEET 

SANITEC RT is an aluminum, cove-shaped profile for wall/floor transitions.
It is ideal for spaces in which frequent cleaning is required, offering a hygienic solution.
The profile is applied before laying the floor and wall covering, making it perfectly integrated into the surfaces.

 

 

 

ACCESSORIES

INTERJOLLY IJ profiles optimize wall-to-floor tile transitions while allowing differential movement. The perforated flange installed behind the wall tiling guarantees secure grip. This cove-shaped profile is hygienic, easy to clean and can replace silicone caulking around shower stalls and bathtubs.



Stainless Steel Steel profiles are made by cold forming sheets of constant thickness, thus differing from the corresponding alu minum and brass versions made by hot extrusion, while maintaining their application and dimensional char acteristics. Stainless steel effectively resists high mechanical stress and is particularly suitable for use in the chemical, food, and hospital sectors, where hygiene, durability, and chemical resistance are essential. Normally pro duced with a semi-gloss finish, a brushed finish can also be achieved by partially removing material using rotating nylon and quartz fiber brushes. This process gives the surface a matte appearance without altering its characteristics. AISI 304 STAINLESS STEEL - EN X 5 CrNi 18 10 - DIN 1.4301: This steel belongs to the AUSTENITIC category and is the most widespread and commonly used alloy for products requiring high technical and performance characteristics. It is highly resistant to most chemical agents but may stain or darken superficially; a standard polishing product is sufficient to restore its original appearance.



PVC RESINTOP Rigid thermoplastic synthetic resin: This material is specifically formulated to optimize the performance of rigid profiles intended for permanent indoor and outdoor applications, where both aesthetic and durability requirements must be met. Produced from primary resin with a Polyvinyl Chloride (PVC)-based composition, it is suitable for a wide range of uses at temperatures up to +60°C. The selected raw material ensures excellent resistance to UV rays, limited mechanical impacts, and strong protection against the stagnation of fungi and bacteria.



DATA SHEET