Walktec SWH anti-slip self-adhesive safety strip
CODE: SWH
.jpg)
.jpg)
.jpg)
,
- Thoroughly wipe off any residue, grease or dirt from the surface and apply primer if necessary.
- Round off the strip ends.
- Remove the protective paper liner and apply the strip uniformly by press-roll.
- Do not apply strips with temperatures below 15 degrees Celsius unless you have pre-heated the strips and the support.
- Regularly brush off impurities from strips to maintain best grip texture.
- For installation on smooth tiles, create small strips with rounded ends and apply them in each tile.
- Seal the strips along the edges to avoid water infiltration under the strips with to avoid detachment.
,